第二棒材厂轧机165方坯改造

Mill Equipment Transformation in the Second Bar Plant of Xigang

郭将平

西林钢铁集团有限公司

摘　要: 西钢炼钢连铸工艺改变后,第二棒材厂采用的连铸坯规格由150mm×150mm×12 000mm改为165mm×165mm×12 000mm,2012年11月初对棒材厂进行技术改造,增加轧机以适应生产工序的变化。选择好轧机机组的类型和组合形式,通过改造减轻现有主机列传动减速机的负荷,降低设备故障率,提高轧机作业率。
关键词: 轧机；技术改造；165mm2方坯；减速机
分类号: TG333
栏　目: 实用技术
出　处: 《冶金与材料》2013年第4期，第 43-45 页（共 3 页）
出版日期: 2013-08-15
知网数据: 下载 57 次（截至 2026-09-29）

Abstract: Specification of continuous cast bar is changed from165mm × 165mm × 12 000mm to150mm × 150mm × 12 000mm in No. 2 line in Xilin iron and steel in October 2012 after continuous cast process reformed. In early November 2012,Bar plant began to transform to increase the mills to adapt to the changes of the new procedure,and good combination of form and type of the column of mills,were chosen in order to reduce the load of the existing host reduction gear,to reduce equipment failure rates and enhance the purpose of the mill operating rates. in order.
Keywords: mill; technology transformation; 165mm2billet; reducer

“知网全文（电脑版）”需登录中国知网或在已订购知网的机构 IP 内访问；“知网公开页”无需登录即可查看摘要，并可按知网规定下载全文。