AOD-LF-VD-CC工艺生产轴承钢洁净度的研究

Research on Cleanliness of Bearing Steel by AOD-LF-VD-CC process

李彬，马忠存

北满特殊钢有限责任公司

摘　要: 利用夹杂物示踪、系统取样、扫描电镜,针对某厂AOD-LF-VD-CC工艺生产轴承钢的洁净度进行了系统研究,分析了工序中氧、氮含量、夹杂物的数量变化。结果表明:脱氧效果基本上达到要求,LF、浇铸过程中发生不同程度地增氮,VD破空后,钢水中的夹杂物数量和粒径均增加。应适当提高氩气搅拌功率,强化软吹效果;连铸过程中要保证全程保护浇注,避免钢液与大气直接接触吸气。
关键词: 轴承钢；洁净度；夹杂物
分类号: TG142.15
出　处: 《冶金与材料》2014年第6期，第 11-13 页（共 3 页）
出版日期: 2014-12-15
知网数据: 下载 124 次，被引 1 次（截至 2026-09-29）

Abstract: A systematic study was conducted on the cleanliness of bearing steel produced by AOD- LF- VD- CC process by inclusion tracer,systematic sampling and SEM,and the oxygen,nitrogen content and amount of inclusions were analyzed. The result has shown that: the deoxidization effect,by and large,meets the requirements,and nitrogen content increases more or less in the process of LF and CC,and the amount and particle diameter of inclusions increases after VD process. Raising argon stirring power appropriately can enhance the effect of soft blowing,and protecting molten steel from absorbing gas directly should be adopted during casting process.
Keywords: bearing steel; cleanliness; inclusion

“知网全文（电脑版）”需登录中国知网或在已订购知网的机构 IP 内访问；“知网公开页”无需登录即可查看摘要，并可按知网规定下载全文。