路面耐磨性试验轮式磨光机控制系统的研制

Development of Control System of Wheel Grinder Used in Road Abrasion Resistance Test

冯海波

黑龙江省冶金研究所

摘　要: 路面成型后要经过几年运营后才能实测,根据实际测得的数据,判断路面物料配比、碾压强度及震动压实等技术参数是否合理。采用轮式磨光机进行路面耐磨性试验,模拟在各种气候和路况条件下路面实际磨损状态,改事后实际检测为事前模拟实验,为路面的铺设提供科学依据,降低道路的施工成本。本文主要针对路面耐磨性试验轮式磨光机控制系统的研制进行了详述。
关键词: 路面；耐磨；轮式磨光机；试验
分类号: U416.2
栏　目: 实用技术
出　处: 《冶金与材料》2015年第5期，第 65-66 页（共 2 页）
出版日期: 2015-10-15
知网数据: 下载 35 次（截至 2026-09-29）

Abstract: It takes several years to measure after the pavement is laid out,and according to the actual measurement data,judgment was done whether the technical parameters is reasonable,such as ratio of pavement material,rolling strength and vibration compaction. The test of road abrasion resistance of pavement was carried out using the wheel grinder and simulating actual road abrasion conditions under the all kinds of climate and road conditions,and instead simulation experiment was operated prior to road pavement actual test in order to supply scientific data for the pavement laying and to reduce the construction cost of road. This paper mainly describes the research on control system of wheel grinder used in road abrasion resistance.
Keywords: road; abrasion resistance; wheel grinder; test

“知网全文（电脑版）”需登录中国知网或在已订购知网的机构 IP 内访问；“知网公开页”无需登录即可查看摘要，并可按知网规定下载全文。